Tuleeko mutkaan virrat, mutta se ei laukea?
Jos mutkaan tulee virrat mutta solenoidi ei silti pelitä, niin täs ois siihen yskään vähä lääkitystä:
Solenoid doesn't fire when you click the trigger.
· If the LED doesn't blink each time you pull the trigger, the trigger microswitch isn't being actuated. Adjust the trigger and check to see if the switch is broken (take the board out and push it with your finger). If the switch is broken, it will need to be replaced (requires advanced soldering abilities).
· Replace the battery (very common). "Dead" batteries occur around 7 to 7.5 volts with most boards. At this point, the board may turn on but the solenoid probably won't click.
· Verify that the dwell setting is at least 12 blinks or 10 milliseconds (also very common).
· Check the main capacitor for damage, often caused by grip panel screws. If damage is apparent, the capacitor or entire board would need to be replaced. This requires moderate/advanced soldering experience to do yourself.
· Check the solenoid coil (red wire wrapped around the solenoid) for damage. Make sure the coil wraps around the bottom of the solenoid and connects to the silver pins sticking through the board. The wire connects to the silver terminals on each side of the solenoid. If either of the the coil wires are broken, the solenoid will need to be repaired (or replaced).
